Amps
[Top] [All Lists]

Re: [Amps] 87a cured

To: Charles Harpole <k4vud@hotmail.com>, "amps@contesting.com" <amps@contesting.com>
Subject: Re: [Amps] 87a cured
From: Hal W5GHZ <w5ghz@yahoo.com>
Reply-to: Hal W5GHZ <w5ghz@yahoo.com>
Date: Tue, 17 Jan 2012 07:02:27 -0800 (PST)
List-post: <amps@contesting.com">mailto:amps@contesting.com>
It is never a good thing to leave electronic equipment in hot, humid 
conditions.  Even those new fancy and expensive rigs hate those conditions.  
The humidity can be absorbed into the pc board and cause sensitive circuits to 
malfunction.  Most IC's have a temperature and humidity range that they will 
operate reliably within.  We have left the days of those old tube radios that 
would drive out humidity with the heat they generated, but we still had to 
contend with electrolytics drying out as now.
 
I used to write test software for IC's before I retired.  We tested all of the 
IC's used in our production plant and did it in a temperature and humidity 
controlled environment.  Most of the pieces of equipment we use today have a 
highly rated pedigree.  We should treat it accordingly.
 
W5GHZ


________________________________
From: Charles Harpole <k4vud@hotmail.com>
To: amps@contesting.com 
Sent: Sunday, January 15, 2012 2:23 PM
Subject: [Amps] 87a cured


For over 5 years, my Alpha has sat in the shack with high humidity and temps of 
30-34C.  During that time, it automatically went to Fault 9... and sometimes 
Fault 20.... when tried to use.  The "go to fault" was all over the map in 
terms of when it would occur but it was usually early after turn on.  The air 
conditioner would be switched on in the shack only during operations.

My very smart friend worked on it several times, including replacing all those 
expensive PIN diodes, but the problem reappeared soon after that.

On advice of several locals, I began recently to run my shack air conditioner 
continuously at about 25C. and set to "Dry."  After abt 40 hours, I tried the 
87a.  Perfect operation resulted with no other changes.  It now drives, outputs 
RF, and in all ways works as it should.

I guess it just likes cool and dry.  Or the local spirits do.  73,

Charles Harpole k4vud@hotmail.com                          
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>