Date: Thu, 25 Apr 2013 18:39:22 -0700
From: Bill Turner <dezrat1242@yahoo.com>
To: Amps <amps@contesting.com>
Subject: Re: [Amps] Measuring tank coil inductance
ORIGINAL MESSAGE (may be snipped):
On Thu, 25 Apr 2013 17:29:02 -0700, you wrote:
I made a temporary hookup which includes the tube, the plate choke, the
bandswitch and the
pi-net components. I intend to set up the tank as follows:
REPLY:
If you're going to use the AADE unit to set the capacitance in-circuit, be
sure to disconnect the plate choke.
Bill, W6WRT
## whoa. A typ 90 uh plate choke on a 80-10m amp will eat 10 pf from the
C1 tune cap on 80m..
A typ 180 uh plate choke will eat 40 pf from the C1 tune cap on 160m band.
## You can see that effect asap when you wire in the load resistor between
anode and chassis...
with mfj on the output. Tweak tune and loads caps for 1:1 swr on mfj.
Then disconnect hot end
of each cap.... and measure how many pf each cap is. This is all with the
plate choke in the circuit, and
bypass cap from base of plate choke to chassis.
## OK, then remove the plate choke, or disconnect top end of plate choke.
You will see asap that the
swr on the MFJ has jumped to 2:1 Retune the C1 tune cap to bring swr back
down to 1:1
## Disconnect hot end of C1 +C2 tune cap..and measure how many pf it is. You
will see that the C1 tune
cap has INCREASED in value. On 80m, with a 90uh plate choke used, it will
increase by 10 pf. On
160m, with a 180uh plate choke used, it will increase by 40 pf. On 160m,
with a 90 uh plate choke used.
it will increase by a whopping 80 pf.
## The tune cap has to be increased a bit to cancel out the XL of the plate
choke on the lowest band used.
It will be less as you move higher in freq.
## Hot ends of BOTH tune and load caps have to be disconnected, to
measure the C of each cap,
or else the two caps will be in parallel, and any lcr meter will simply read
the sum of the 2 x caps.
later......... Jim VE7RF
via the tank coil between em.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps