| To: | amps@contesting.com |
|---|---|
| Subject: | [Amps] Blade power supply |
| From: | mikflathead@aol.com |
| Date: | Fri, 5 Jul 2013 18:41:01 -0400 (EDT) |
| List-post: | <amps@contesting.com">mailto:amps@contesting.com> |
Is there an available connector to connect the input 220 and output 50 volt connectors to the outputs of these type power supply. A spade terminal kinda works but will not go on all the way do to the taper on the male lug. Any creative ideas out there? Thanks Mike _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Amps] premade HV rectifier board, Jim W7RY |
|---|---|
| Next by Date: | Re: [Amps] Blade power supply, qrv@kd4e.com |
| Previous by Thread: | [Amps] Dedicated RF, key |
| Next by Thread: | Re: [Amps] Blade power supply, qrv@kd4e.com |
| Indexes: | [Date] [Thread] [Top] [All Lists] |