Amps
[Top] [All Lists]

Re: [Amps] HV transformer and Variac

To: amps <amps@contesting.com>
Subject: Re: [Amps] HV transformer and Variac
From: Ron Youvan <ka4inm@gmail.com>
Reply-to: ka4inm@gmail.com
Date: Fri, 24 Jul 2015 13:20:22 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
On 07/24/2015 12:33 PM, Gerald Williamson via Amps wrote:

Hi Larry, thanks for adding that analysis.

Your approach clears up something that has bothered me about Variacs for a
long time: When you examine the tap/brush part of the device it is obvious
the  more then one turn of the autotransformer is being connected to the
sliding  tap at the same time. That means that one or more turns are shorted.

A shorted turn in a conventional transformer will result in a large current
  flow, copious amounts of smoke and likely some sparks as well.

  Your analysis omitted the two resistors in the circuit, one
contacting each turn, they are made of a carbon block, if you
substitute copper or brass for the carbon brush you *will* blow
the fuse.
Powerstats (or Variacs) are a compromise that are more economical that using a rotary transformer, (that uses no brushes) but cost big
and are (as rule) very noisy.  (audible HUM!)
 Powerstats (or Variacs) do the job, give little trouble and are not
terribly inefficient.
--
  Ron  KA4INM - Youvan's corollary:
                Every action results in unwanted side effects.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>