Make a shorting stick -- a dry wood or fiberglass stick about 16" long with a
hook at one end, and a wire from the hook going to a good-quality alligator
clip. When you open the amplifier, connect the clip solidly to the chassis and
touch various spots in the power supply and plate circuit with the hook, and
then hook it to a hv point and leave it there while you work.
Use it religiously -- never open the amp without it no matter what. Just
another level of security.
> On 1 Nov 2016, at 04:10, Catherine James <email@example.com> wrote:
> OK, found schematics (thanks Bob W1ICW). Looking at the glorified voltage
> divider, I'm guessing it's just an open resistor on the meter board. I'll
> have a closer look at it later this week.
> Hoping the meter coil isn't bad...
> Amps mailing list
Amps mailing list