How about a key up spike in TX power ?
On 9/15/2019 1:36 PM, Ron Youvan wrote:
Guido Tedeschi wrote:
A friend asked to me why the pair of almost new FU728F tubes on its
commercial PA goes south.
It seems that, when tubes are warm, there is a short between Grid1
and Cathode on both tubes and, when the PA PTT is activated, it
reboots again with the 3 minutes warmup delay.
So, he asked to me why both tubes were damaged but I was not able to
answer, because:
- The PA is less than 3 years old and it has been used for less than
300 hours.
- The amp was used 99% at about half of the maximum power
- The TX power is limited by menu to 50W (FTDX-5000MP)
- Mains voltage was always between 220 and 230V
- Antennas are fine
- The PA is claimed to be protected against almost everything...
Normally, I think that it would happen when the tubes grid is
overdrive, but the power was every time much lower than 50W and,
anyway, the amp "is protected", so, why it did happens?
Any idea?
You did not mention the actual heater power.
--
Rick, W8ZT
WVDXA
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|