Similar issue, removed the old fiberglass type supports. Used sheet of
plastic about 3/16" thick and cut new somewhat square supports, could have
been 1/4".
The sheet is ldpe type plastic. Found LPDE local - 1x1 foot piece and
bought it.
ebay should have something too
https://www.dropbox.com/s/cnftynpvjquc9fu/2x400amp.jpg?dl=0
link should show amp with good enough resolution to zoom into new supports
.... Work in progress
73 W5AJ
On Fri, Aug 7, 2020, 12:31 PM Mike Keller <w1bnc52@gmail.com> wrote:
> I was fortunate to save a Classy home brew 2 / 4-400 KW amplifier in a 4ft
> rack from a trip to the landfill and am trying to bring it back to life.
> The coil support rods in the B+W 850a are missing and I am looking for
> suggestions for replacements.
>
> Mike Keller
> W1BNC
>
> Typos bye iPhone
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|
