To: | antennaware@contesting.com, w7el@eznec.com |
---|---|
Subject: | [Antennaware] Problems on a 2el Vertical Array |
From: | Tobias Wellnitz <T.Wellnitz@gmx.de> |
Date: | Thu, 08 Jan 2004 01:37:50 +0100 |
List-post: | <mailto:antennaware@contesting.com> |
Hi guys,over Christmas I set up a 2el vertical Array for 40m. I used 60 quaterwave long radials for each vertical. The spacing is 7m and I wanted to phase them with 123° (which seemed for me to be the best trade between ground-losses and f/b). I calculated the following impedances, using EZNEC with Mininec ground. (incl 3 Ohms ground losses): Ant1: 30,7 +j31,4 Ohm Ant2: 19,2 -j16,9 Ohm Applying the Christman method, I obtain the following cable length (RG-213 - vel. factor 0,66) to Ant1: 8,43m to Ant2: 13,79m At the common point of the cables I calculated the following Impedance: Z = 34,4 +j3,7 ----so far the theory----- In order to build up the array as precise as possible, I messured the Z-parameters with an MFJ-259b: Z11 = 37 +j3,7 Z21 = 25,0 +j13 Z12 = 25,0 +j13 Z22 = 37 +j7 Out of this I calculated the drive impedances (I skip the details): Ant 1: 22,3 -j9,9 (1A / 0°) Ant 2: 27,5 +27,3 (1 / 123°) out of this values I calcuated following cable length (RG-213): to Ant1: 10,4m to Ant2: 14,92m At the common point of the cables I calculated the following impedance: Z = 38,8 +j7,36 I realised the array with the measured values. While testing the array on the air, I made several hundert QSOs on 40m (as DA0BCC) around X-MAS. I was able to hear / "feel" about 3-4dB additional dBs over one single vertical. But I'm unhappy with the f/b ratio. The pattern shows, that I should have at least 10dB on EACH station and 15-25dB f/b on DX stations. I heard only a few DX stations where I really had 25dB f/b... but this was the big minority (maybe 5 out of 100). Often I didn't notice any f/b at all. (especially on stations closer than 2500km). Right now I have two possible answers / questions: 1. Is this the typical behavior of a 2el vertical Array ? 2. Did anyone set up such an array, using the messured values ? 2.5 How MUCH can I trust that MFJ 259b ????
Best greetings, 73 Toby, DH1TW _______________________________________________ Antennaware mailing list Antennaware@contesting.com http://lists.contesting.com/mailman/listinfo/antennaware |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [Antennaware] RE: Antennaware Digest, Vol 13, Issue 1, Mel |
---|---|
Next by Date: | Re: [Antennaware] Problems on a 2el Vertical Array, Davor Virkes |
Previous by Thread: | [Antennaware] RE: Antennaware Digest, Vol 13, Issue 1, Mel |
Next by Thread: | Re: [Antennaware] Problems on a 2el Vertical Array, Davor Virkes |
Indexes: | [Date] [Thread] [Top] [All Lists] |