Antennaware
[Top] [All Lists]

Re: [Antennaware] Low RF Output on Butternut Vertical Help???

To: <antennaware@contesting.com>
Subject: Re: [Antennaware] Low RF Output on Butternut Vertical Help???
From: "John Wagner" <jwagner@dxengineering.com>
Reply-to: jwagner@dxengineering.com
Date: Wed, 19 Oct 2005 12:28:39 -0400
List-post: <mailto:antennaware@contesting.com>
Maybe try a good Line Isolator/ Feedline Current Choke to get rid of the
common-mode current.

73 John

> -----Original Message-----
> From: antennaware-bounces@contesting.com 
> [mailto:antennaware-bounces@contesting.com] On Behalf Of K9AY
> Sent: Wednesday, October 19, 2005 12:02 PM
> To: OTAKEBI@aol.com
> Cc: antennaware@contesting.com
> Subject: Re: [Antennaware] Low RF Output on Butternut Vertical Help???
> 
> 
> Dan,
> 
> I'm willing to bet that you have RF floating around on 
> shields and grounds. The added coax changed the system enough 
> to reduce the problem in the shack, but increase the RF in 
> the Satellite system.
> 
> Grounding and chokes may help, but sometimes there is simply 
> too much RF coupled into the various wires due to the 
> proximity of the antennas. I knew one ham who had a multiband 
> vertical in his back yard and just couldn't do anything to 
> keep RF out of his neighbors' telephones. When he switched to 
> an inverted-vee off his 40-foot tower, the phone RFI went 
> away, but more distant stations couldn't hear him as well. 
> The cause could have been stronger coupling with vertical 
> polarization, or the actual in-ground currents induced by the 
> vertical and its radials. I think it was the latter.
> 
> Gary
> K9AY
> 
> 
> 
>   ----- Original Message ----- 
>   From: OTAKEBI@aol.com 
>   To: k9ay@k9ay.com 
>   Cc: antennaware@contesting.com 
>   Sent: Wednesday, October 19, 2005 9:28 AM
>   Subject: Re: [Antennaware] Low RF Output on Butternut 
> Vertical Help???
> 
> 
>   Gary, last night I added 5 feet of coax with a barrel connector.
>   All fine now on 20 meters.
>   I am getting full output on 20 without tuner and the radio 
> is not drawing the high amps that were causing it to trip the breaker.
>   However, the TV in the bedroom which on Direct TV developed 
> bad RFI with the added coax.
>   It was not doing that before and the dish is on the other 
> side of the antenna from the house where the Butternut is.
>   Very strange.
>   10 meters also went up to 80 watts output without tuner.
>   Any ideas as to what took place?
>   Thanks,
>   Dan N4VET
> _______________________________________________
> Antennaware mailing list
> Antennaware@contesting.com 
> http://lists.contesting.com/mailman/listinfo/antennaware
> 
> 


_______________________________________________
Antennaware mailing list
Antennaware@contesting.com
http://lists.contesting.com/mailman/listinfo/antennaware

<Prev in Thread] Current Thread [Next in Thread>