CT-User
[Top] [All Lists]

[ct-user] FT1000(not D or MP) rig interface problem

To: <ct-user@contesting.com>
Subject: [ct-user] FT1000(not D or MP) rig interface problem
From: jjreisert@alum.mit.edu (Jim Reisert)
Date: Mon, 19 Nov 2001 11:58:24 -0800 (PST)
I also should have added:

You never need to specify -b<baud rate> to the COMTSR.  This is controlled by
the CT program itself, not the COMTSR.  Just enter the correct baud rate in the
CT SETUP screen.

- Jim

--- kb3aug@juno.com wrote:

> Pete, When you loaded the comtsr I did not see where you loaded the -I
> for IRQ number. Did you forget to do that? Mine is comtsr1 -b4800 -n82
> -i4.

You only need to specify -I when the IRQ is non-standard.  COM1 is usually IRQ4
and and COM2 is usually IRQ3.  These are the defaults for COMTSR1 and COMTSR2
respectively, there is not usually a need to specify them in the command
line.

If you load a COMTSR without any parameters, it will report the default
settings for that port. You only need to specify differences from the
default.

- Jim



=====
Jim Reisert AD1C, 7 Charlemont Court, North Chelmsford, MA 01863
USA +978-251-9933, <jjreisert@alum.mit.edu>, http://www.ad1c.com

__________________________________________________
Do You Yahoo!?
Find the one for you at Yahoo! Personals
http://personals.yahoo.com

<Prev in Thread] Current Thread [Next in Thread>