I don't know if a relay would fast enough to do CW keying.
I would use a high voltage transistor or opto isolator such as the
H11G1 which has a 100V BVceo. If that isn't high enough, there
probably are others out there that are higher.
Pin 17 of LPT1 has the CW output, pins 18-25 are ground.
At 1/8/2009 05:27 AM, poldo wrote:
>I use CT 9.72
>For cw/keying my rig (negative grid block transmitter) via LPT port I need a
>5 Volt relay switched by CT
>Could someone provide me with a pinout for switch the relay ?
>Thanks
>Ed IV3TQE
>
>
>_______________________________________________
>CT-User mailing list
>CT-User@contesting.com
>http://lists.contesting.com/mailman/listinfo/ct-user
>CT on the web: http://www.k1ea.com/
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
|