>greetings to all...used na 9.26 in last nights sprint and ran into a few
>problems...the enter key on the numeric keypad wont work to send a
>packetspot(alt f3)...neither enter key works on the delay command (
>change the cq/f1 rate) delay brings up the window the arrows let you
>change the delay in seconds but then the only way to exit is via the esc
>key and the delay is not changed...when pressing f8 to do a check partial
>most of the time i got dumped to dos with a error 63 occured in scr_ovl
>module..i was configured as single op but had tnc on com2 4800/irq 3 (by
>the way when you bring up the tnc config both ports default to irq2 (?))
>on a 386sx with 4meg ram w9xt card on lpt2...73 Jamie WW3S
>
>
Hi, Jamie. Well after cursing and swearing for about an hour before the sprint,
I finally gave up trying to network 2 computers with NA. Even then, I couldnt
get all my IO devices to work at once. I went to running a single computer
with only a radio interface: no packet and no DVP. At least that held up.
I tried so many different configs trying to get everything to run, I just about
bagged the sprint. One thing that happened along the way is that I couldnt
access the SETUP screen to change any of the ports. It would flash the box
outline momentarily on the screen and immediately dump back to the callsign
box. Config attempted: Single Op all band Sprint SSB - Network COM1 9600
IRq 3, Packet remote, FT1000 on COM3 IRQ 10, w/ DVP (IRQ 5) running MSDOS 6.21
on a 386DX25. My other computer runs Windows 95 and MSDOS 7. I never
did get the DVP to work at all on this one under either operating system.
Frustrated!
>--
>Submissions: na-user@ve7tcp.ampr.org
>Administrative requests: na-user-REQUEST@ve7tcp.ampr.org
>Questions: owner-na-user@ve7tcp.ampr.org
>
--
Submissions: na-user@ve7tcp.ampr.org
Administrative requests: na-user-REQUEST@ve7tcp.ampr.org
Questions: owner-na-user@ve7tcp.ampr.org
|