Ron,
I'm pretty sure you need a stereo 1/4 plug for the key in. My FT-1000Ds
are that way. RYFM.
Second, turn off the internal keyer.
That should set you up.
73,
Dave
At 12:52 AM 5/20/01 +0000, Ron Wetjen wrote:
>Have been using the LPT CW interface described in the NA manual to key
>my TS-930 ... using pins 1, 17, and 18. For the 930, used a mono-phono
>plug, the pin 1 and 17 combo went to the tip, and pin 18 to ground.
>Don't need the PTT lines, since I'm not using an amp. This setup worked
>fine on a 930 and a 450 just last weekend.
>
>Just upgraded to an MP, and now can't get the interface to key the rig.
>Switched to a 3 contact stereo plug, and using the same configuration,
>I'm getting a string of dits when I connect the pin 1 and 17 combo to
>the pin or a string of dashes when I connect to the ring.
>
>Tried a N3JT CW interface, and I'm getting a string of "di-dahs" with
>that!!
>
>This can't be that difficult to figure out, but it's got me whipped!
>
>Anyone using the LPT CW interface or N3JT interface and clue me in to
>the proper connections to key the rig?
>
>Thanks, Ron
>
>--
>Submissions: na-user@contesting.com
>Administrative requests: na-user-REQUEST@contesting.com
>WWW: http://datom.contesting.com/
>Questions: owner-na-user@contesting.com
--
Submissions: na-user@contesting.com
Administrative requests: na-user-REQUEST@contesting.com
WWW: http://datom.contesting.com/
Questions: owner-na-user@contesting.com
|