Hi Steve,
Does the RFI affect only one antenna on receive or multiple
antennas?
Suggest you have someone visit your shack and listen on the
harmonic frequency and observe your spectrum display on the
harmonic frequency as you jostle things up on the tower.
Not as effective -- because you can't remotely watch as S-meter
or spectrum display on the harmonic frequency -- you could listen
to your receiver audio through a cell phone or handheld transceiver.
Possible causes:
- worn coax cable loop from constant rotation or wind exposure.
You should be able to observe this on your TDR from inside your
shack if you own a TDR. If you don't own a TDR, purchase one!
Its one of the best tool investments you'll ever make. Reflected
power may also vary if the coax is severely worn.
- arcing inside your thrust bearing
- arcing ring rotator surfaces
73
Frank
W3LPL
----- Original Message -----
From: "k1ttt dave" <k1ttt.dave@gmail.com>
To: "Steve London" <n2icarrl@gmail.com>, rfi@contesting.com
Sent: Sunday, August 8, 2021 7:48:00 PM
Subject: Re: [RFI] DFing intermittent connection
I would go up with a long pole (preferably fiberglass or some other
insulator) and start whacking things to see if you can stimulate it. Also
pull and push on all the cables, check that connections are tight, look for
rubbed through insulation on rotor loops, etc. I had one once that would
generate a sub-harmonic, 20m tx caused 40m subharmonic and then also 15m
3/2's harmonic, must be a puncture in hardline jacket somewhere that would
arc and excite a resonance in a certain length of hardline... adding ground
connection to the connectors at the top of the tower stopped it. I had been
hunting it for weeks with all sorts of tools and wouldn't have found it if I
didn't push and pull on the (totally unrelated to 20m or 40m) cables while
someone was monitoring it.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://wiki.k1ttt.net
AR-Cluster node: telnet://k1ttt.net:7373
-----Original Message-----
From: RFI <rfi-bounces+k1ttt=arrl.net@contesting.com> On Behalf Of Steve
London
Sent: Sunday, August 8, 2021 15:19
To: rfi@contesting.com
Subject: [RFI] DFing intermittent connection
This is a little off topic from the usual, but the expertise in DFing on
this forum is outstanding.
I am a serious contester, and do lots of SO2R. That means I need to be able
to listen on one band while transmitting on another band. With filters and
stubs I have brought the harmonic and overload energy down to acceptable
levels. However, I have recently developed a new problem. Something on the
tower is intermittent and causing the level of the 2nd harmonic to vary many
S-units as the wind blows or I turn the rotator on the 40 meter beam.
When this happens it creates hash across the band. I have looked for the
obvious, but no luck yet. Yes, it could be something loose on the 40 meter
beam hardware, but before I take on the project of taking it down, I would
like to pinpoint the source. I am a tower climber, so I can get close to
everything on the tower. What are the options for something handheld, very
directional, and not overloaded by the fundamental ?
73,
Steve, N2IC
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|