The kit is basically a very heavy, very flexible cable, six feet or so, with
lugs on both ends, and clamps with a large flat surface to attach to the mast
and to the tower leg. I'd think that the bottom lug could be attached to a
tower bolt, or some other low resistance connection to the tower.
It would seem to also be simple to homebrew something a bit less rugged,
perhaps using a piece of RG-8, shield and center conductor connected together.
73 - Jim K8MR
-----Original Message-----
From: EDWARDS, EDDIE J via RFI <rfi@contesting.com>
To: RFI List <rfi@contesting.com>
Sent: Mon, Aug 16, 2021 9:09 am
Subject: Re: [RFI] DFing intermittent connection
Just FYi...They told me they only have the bypass kits for standard Rohn
towers, but not for the BX or HDBX series towers. Need to make your own for
other non-rohn configurations.
73, de ed -K0iL
-----Original Message-----
From: RFI On Behalf Of jimk8mr--- via RFI
You might look into DX Engineering's Bearing Bypass Ground Kits DXE-BBGK-2-25-P.
I installed one yesterday for K8AZ. I'm not sure if Tom had a particular
problem or it was just as a precaution. It easy to install, the only issue in
my case was that the tower had been painted, so some paint scraping was in
order. But much easier than replacing a thrust bearing!
73 - Jim K8MR
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|