RFI
[Top] [All Lists]

Re: [RFI] DFing intermittent connection

To: donovanf@erols.com, rfi@contesting.com
Subject: Re: [RFI] DFing intermittent connection
From: K9MA <k9ma@sdellington.us>
Date: Mon, 16 Aug 2021 16:27:16 -0500
List-post: <mailto:rfi@contesting.com>
Gee, it's worked for me for years. Not much salt spray in Wisconsin.

73,
Scott K9MA

On 8/16/2021 12:32 PM, donovanf@erols.com wrote:
Jim,

Please ignore Scott's advice, it will cause tower corrosion and quickly fail

73
Frank
W3LPL

------------------------------------------------------------------------
*From: *"K9MA" <k9ma@sdellington.us>
*To: *jimk8mr@aol.com
*Cc: *rfi@contesting.com
*Sent: *Monday, August 16, 2021 4:30:35 PM
*Subject: *Re: [RFI] DFing intermittent connection

Or just use the braid from some RG8 and a couple hose clamps.



----------

Scott Ellington. K9MA

 --- via iPhone

> On Aug 16, 2021, at 9:27 AM, jimk8mr--- via RFI <rfi@contesting.com> wrote:
>
> The kit is basically a very heavy, very flexible cable, six feet or so, with lugs on both ends, and clamps with a large flat surface to attach to the mast and to the tower leg. I'd think that the bottom lug could be attached to a tower bolt, or some other low resistance connection to the tower. > It would seem to also be simple to homebrew something a bit less rugged, perhaps using a piece of RG-8, shield and center conductor connected together.
>
> 73  -   Jim   K8MR
>
>
>
> -----Original Message-----
> From: EDWARDS, EDDIE J via RFI <rfi@contesting.com>
> To: RFI List <rfi@contesting.com>
> Sent: Mon, Aug 16, 2021 9:09 am
> Subject: Re: [RFI] DFing intermittent connection
>
> Just FYi...They told me they only have the bypass kits for standard Rohn towers, but not for the BX or HDBX series towers.  Need to make your own for other non-rohn configurations.
>
> 73, de ed -K0iL
>
> -----Original Message-----
> From: RFI On Behalf Of jimk8mr--- via RFI
>
>
> You might look into DX Engineering's Bearing Bypass Ground Kits DXE-BBGK-2-25-P. > I installed one yesterday for K8AZ. I'm not sure if Tom had a particular problem or it was just as a precaution. It easy to install, the only issue in my case was that the tower had been painted, so some paint scraping was in order. But much easier than replacing a thrust bearing!
>
> 73  -  Jim   K8MR
>
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi

_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi


--
Scott  K9MA

k9ma@sdellington.us

_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
<Prev in Thread] Current Thread [Next in Thread>