Earlier, I wrote
> Rather than trying to configure SD on the fly, I'd like to create a
> template file for the Minnesota QSO party next month (rules here:
> http://www.w0aa.org/mnqp_rules.htm).
>
> I've tried building one out of parts from other templates, but haven't
> got it quite right (it wants to log signal reports when the exchange is
> just name and s/p/c).
Still trying to get this right, I found that with no other changes, if I
used "NAQP.MLT" as the multiplier file, it worked correctly, but if I
used my own "MNQP.MLT", it reverted to wanting to send and log signal
reports. I tried substituting a few other state QSO party MLT files and
got the same result.
What is it about the MLT file that's causing this effect? Here's what it
looks like:
# This is MNQP.MLT -
# For the MN side of MNQP
#
$K
$KH6
$KL
$VE
#
#
#
AIT = Aitkin
ANO = Anoka
... Minnesota counties
WSH = Washington
YEL = Yellow Medicine
AK =Alaska
AL =Alabama
... states
WV =West Virginia
WY =Wyoming
AB =Alberta
BC =British Columbia
... Canadian provinces & territories
YUK =Yukon
--
Bert Hyman W0RSB St. Paul, MN bert@iphouse.com
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|