If the power supply is too close to the OMNI VI, it will
make a buzz on transmit. Try moving the power supply.
Carl Moreschi N4PY
Franklinton, North Carolina
carlmoreschi@worldnet.att.net
----------
> From: Roy Koeppe <royanjoy@ncn.net>
> To: Ten Tec Reflector <tentec@contesting.com>
> Subject: [TenTec] Re: Raspy note on OMNI-6
To: <tentec@contesting.com>
> Date: Monday, December 13, 1999 11:42 PM
>
>
> About,
>
>
> "Out of the blue, my Omni 6 (opt 3) has developed an
> intermittent rasp (buzz) on the trailing edge of cw
> notes. SSB sig sounds fine. It's on all bands, with
> all antennas, including a dummy load. It's audible as
> a hum in the monitor or as a rasp on a second
> receiver.
>
> Would greatly appreciate any help from knowledgable
> folks out there."
>
> Best holiday wishes to all & 73,
> Barry N1EU
>
>
> Barry,
>
> Does the buzz seem to reference to 60 or 120 Hz? If so, that ordinarily
> can only mean it originates in the power supply.
>
> Good shooting and 73,
>
> Roy K6XK
>
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|