TenTec
[Top] [All Lists]

[TenTec] OMNI V -- RF Leakage

To: <tentec@contesting.com>
Subject: [TenTec] OMNI V -- RF Leakage
From: K2ZF@aol.com (K2ZF@aol.com)
Date: Wed, 8 Mar 2000 20:03:08 EST
Bill, I would try replacing the molex connector from the power supply. That 
connector when its old and dirty can produce alot of strange problems. When 
the rig requests higher current from the power supply and flows through the 
connector can result in many problems. The front panel can freeze up, the rig 
can kinda shut down but not all the way as when the circuit breaker in the 
power supply trips, the received and transmit signals can sound terrible. If 
the molex connector is at fault then a mirco-processor reset will not fix the 
problem. The connector tubes tend to separate after a time, not making proper 
contact with the male counterpart.
Before you send the rig back please replace the molex connector, you just may 
be suprised that problem was not as bad as you suspected.
Good luck de K2ZF (Jim)

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>