TenTec
[Top] [All Lists]

[TenTec] Ground Loop ?

To: <tentec@contesting.com>
Subject: [TenTec] Ground Loop ?
From: tacquire@earthlink.net (Dan)
Date: Mon, 06 Nov 2000 10:46:33 -0800
Not sure how to solve your problem.  I quit playing with SSTV because I could
"listen" fine on the computer and get decent pictures but if I tried to key my
transmitter the audio would come across my computer in a highly irritating way.

Mark Erbaugh wrote:

> I've built an interface between my computer sound card and the Accessory
> jack on my Pegasus.  This seems to work fine. I'm attempting to add PTT
> control via a computer serial port. I've tried two different interfaces, the
> one printed several times in QST that uses a transistor, a resistor and a
> couple of diodes. In this interface, the grounds of the radio and the
> computer are connected, With my Pegasus (and also with it's predecessor Omni
> V) I get some hum on my transmitted signal, if the PTT interface is
> connected to the computer serial port.  If I unplug the interface and use
> other means to key the Pegasus, the transmitted signal appears hum free. I'm
> just reporting results from monitoring the signal with the TX monitor.  I
> figured that since the grounds were common in the interface that that might
> be the source of a ground loop, so I rebuilt the interface using an
> opto-isolator where nothing is common.  I still get the hum.
>
> On other thing to mention that may be a factor. I recently added dedicated
> 110V electrical wiring for my ham shack.  I now have a home run directly to
> the breaker box and thus I know that the ground pin on the 110V plug is
> wired properly. Previously, I was using a 2 prong outlet that had been
> replaced with a 3 prong outlet, but I don't know if the ground wire was
> really any good.  My station ground is a couple 6 foot copper ground rods
> buried a few feet from the electrical ground. I ran a piece of heavy cooper
> wire from the station ground to the electrical ground rod, but it is not
> silver soldered, just an acorn clamp on both ends.
>
> Mark
>
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/tentec
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>