I just did the 1.14 update and it works fine. A big thank you to
Ten Tec on this one. The
reduced power function on tune is what I have been asking for. It
works fine. I went
from SSB (full power) to tune (about 20 watts or so) and then back
to SSB and it is at full
power again. I love it. Thank you TT!!!
Duffy - WB8NUT
2/7/02 7:01:20 PM, WmLB@prefer.net wrote:
Yes.. that would seem to be the case all right.
I certainly have no issue with the "Tune" function reducing power.
It's probably a good innovation.. But.. your right.. it should not be
a "sticky" function in the processor and one should not have to do
anything (like pressing the "power" button) to restore set power
levels.
The guy I talked to at Ten-Tec said the software guy was home with
the flu, so it looks like it might be a day or more before they
resolve it.
Bill, W6WLB
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
______________________________________________________________________
J. Duffy Beischel - Amateur Radio WB8NUT
Member of: ARRL, NRA, Kiwanis, Republican Party, Masons, and Shriners
and the vast Right Wing conspiracy to get the Clintons
"If the government owned all the guns, would we still be a free people?"
______________________________________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec