TenTec
[Top] [All Lists]

[TenTec] Bulb replacement in Model 238 Tuner

To: <tentec@contesting.com>
Subject: [TenTec] Bulb replacement in Model 238 Tuner
From: gr1ns@aol.com (gr1ns@aol.com)
Date: Sat, 15 Jun 2002 21:50:36 EDT
Hi Gang,

I have a burned out bulb on the meter in my tuner.  The manual on page 2-8 
under "PILOT LAMP REPLACEMENT" calls for the 14 Volt, bayonet type, No. 1813 
or 1892.  It states further that access to these bulbs is obtained by 
removing the top cover of the unit.  My question is which bulb is used from 
the Ten-Tec factory for the meter?  It gives one the impression that either 
of these bulb types can be used, but I want it to match the light in the 
meter of the Omni, VI Plus, so thus the reason to ask, which comes original 
from the factory?  Can you get these at Radio Shack, or some other easy to 
find outlet?

My second question is to remove the top appears to involve a total of 8 
screws on the sides of the unit.  If I remove these 4 screws per side, does 
the entire cover come off?  Does it require loosening or removing any of the 
front panel screws?

Finally, I run the light in the Omni at a reduced brightness to help 
facilitate its life, has anyone used a dropping resistor to drop the voltage 
to the meter light, making it effectively last longer?  If so, what kind of 
value would be used to cut it roughly by 25% in brightness and what size i.e. 
1/4 watt, 1/2 watt, etc.?

Thanks,

Michael Kelly, K5AWI



<Prev in Thread] Current Thread [Next in Thread>