Tim and the list -
This sounds like a simple jumper "mod" I did once to give me sweeter
(wider) audio from use of the single 9 MHz IF filter. You might
carefully check around the base of the filter for a small resistor and
cap across the active leads jumpering the filter. This sounds like a
good avenue since you mention you can remove the 1.8 filter to no
effect. This indicates to me that either 1) there is a jumper; or 2)
the NAR button is inoperative.
Good luck.
Clark
WA3JG
On Thursday, February 27, 2003, at 09:32 PM, <tlogan7@cox.net> wrote:
Hi folks -
Regarding my 1.8 filter that does not work, I tried Ron's test, below,
with
the PBT at 4 o'clock and found no difference. Then I opened the rig and
pulled the filter out of the slot while the radio was operating and the
1.8
selection button was on - there was no difference in reception. Having
had
an Omni V, I know what the 1.8 should sound like and it's definitely not
|