----- Original Message -----
From: "WILLIAM MANSEY" <wa2pvk@msn.com>
> I used George's method of checking and aligning TCXOs on
> both my Argonaut V and Orion.
Ok, I have George's (W5YR) method using MixW working just
fine; my Orion is high in frequency by about 26 Hz. This is not
satisfactory! Especially since now I have my RX-340 "dead on"
via the hp GPS rcvr set up!
My question: where is the TCXO alignment adjustment on the
bottom of the Orion. I know I must remove the bottom plate,
but where do I look, and what should I see? I assume the
adjustment is somewhere on the A10 board, the Synth card.
Special tool needed?
73, Jim KH7M
|