TenTec
[Top] [All Lists]

Re: [TenTec] Opinions on StepIR vertical

To: dock0evz@earthlink.net, tentec@contesting.com
Subject: Re: [TenTec] Opinions on StepIR vertical
From: Bill Miner <wg6h@postoffice.pacbell.net>
Reply-to: wg6h@pacbell.net, tentec@contesting.com
Date: Fri, 10 Oct 2003 09:43:54 -0700
List-post: <mailto:tentec@contesting.com>
Doc,

The performance of a vertical antenna is dependent on good ground
conductivity out to 100 wavelengths!  With you mountain QTH  you will do
much better with horizontal polarization.  

How about a one or two element StepIR  on a modest tower.

73 & GL
Bill - K6WLM

Doc K0EVZ wrote:
> 
> Gang:
> 
> I need help!  Am at a new location in the mountains east of Albuquerque,
> NM.  Now comes the challenge of putting together an antenna farm.  I
> believe a vertical or vertical dipole might be the best/fastest way to get
> going.  Cannot get the funds together right now for a quad or yagi.
> 
> We are at 6630' ASL, on the top of a gently rolling hill with a good
> 360-degree look from our house.  The ground is normally dry with lots of
> large and smallrocks.  This is high desert country. Part of my question is
> whether to go with a vertical or a horizontal wire antenna, such as the 88'
> doublet fed with ladder line, or maybe the IAC double bazookas I had such
> terrific results with in North Dakota for the past four years.
> 
> Therefore, please make some recommendations.  I have successfully used a
> GAP Titan DX in two previous QTH, with very good results.  Perhaps I should
> just buy another one for here.  OTOH, I have been sorta eyeing the StepIR
> antennas.  Can someone help me decide?  Or are there even better ideas from
> someone?
> 
> Thanks in advance for any assistance.
> 
> 73,
> --Doc/K0EVZ
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>