TenTec
[Top] [All Lists]

Re: [TenTec] 450 ohm Feed Line - N1SU

To: tentec@contesting.com
Subject: Re: [TenTec] 450 ohm Feed Line - N1SU
From: ac5e@comcast.net
Reply-to: tentec@contesting.com
Date: Thu, 15 Apr 2004 12:00:50 +0000
List-post: <mailto:tentec@contesting.com>
Well - before I get lost trying to make an individual reply again I guess I 
will just reply to the list. 

Jason, I understand the ladder lock will work quite well, although I have never 
used one myself. I would NOT attach your dipole's feedpoint directly to your 
tower - unless you have a wooden tower. Being cheap, I use the homebrew 
standoffs at the farm, where one run of the stuff is over 300 feet without 
other supports. That setup has been up since 1996, without problems. 

I do have a pair of 100,000 ohm wirewound resistors, one from each side of the 
ladder line to ground, to drain static electricity off. Array Solutions has an 
RF choke to do much the same thing - or you can wind six to eight inches of 
small diameter insulated wire on PVC and build your own. I used the spark plug 
lightning arrestor back in the 1950's and was never satisfied with performance. 
I do use a purpose built dual gas tube arrestor at the farm. 

I don't use ladder line here, since getting even coax in and out is a pain. 
Basicly, I use a 6 foot section of salvaged galvanized water pipe with a pulley 
at the end to stand my dipole's center support to the tower. 

The pipe is U-bolted (galvanized U bolts) to two of the tower legs just under 
the rotor shelf; and the pulley stands almost four feet off the tower.  The 
haul line (parachute cord from the Army Navy Surplus store) from the pulley 
goes to a foot long section of 3/4 inch PVC for extra insulation, with a 
locking carabiner between the PVC and the Alpha Delta's center insulator. This 
setup served for about 8 years without noticable deterioration, until I went 
nuts and tried to shoehorn a shortened 160 dipole into the same space. After a 
couple of years I went back to the DX-CC. 

The original haul line is a little stiffer than when I put it up in 1990 - but 
it's still plenty strong. From experience, everything should be galvanized 
unless you want to go to a lot of trouble separating the non-galvanized parts.  
Everything else looks quite well, even after two hurricanes and a line squall 
that tore down most of the trees in the area. 

Hope that helps and 

73  Pete Allen  AC5E

--
Never squat with your spurs on
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • Re: [TenTec] 450 ohm Feed Line - N1SU, ac5e <=