Was wondering if anyone has experienced the following. I noticed when switching
from SSB to CW modes the ALC light will not come on until a couple of seconds
(2 to 7 seconds) of operating in the new mode selected. It does not seem to
matter when switching from CW to SSB or SSB to CW.
I also noticed on 21 mhz as well as 24 and 18mhz the ALC light will not operate
at all when operating at 100 watts. If I turn the pwr down it will begin to
light with the cw. It does not seem to matter if the tuner is in line or not. A
master reset did not have an effect on the problem either. The rig seems to
operating normal when in CW without the ALC light blinking on and off but does
have an effect on SSB (as far as I can tell). I am really puzzled by this one
and any help or comments will be appreciated.
v/r Frank (KA4JQZ)
---------------------------------
Do you Yahoo!?
Read only the mail you want - Yahoo! Mail SpamGuard.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|