[TenTec] OMNI VI+ Logic Board

["Joe Simpkins" <K4MD@carolina.rr.com>]

Would there be anyone on this reflector that might help me determine a plug 
and pin configuration?
After removing the 4 screws of the top of this radio, one can see the logic 
board on the right hand side of the radio facing you. There is a 6 pin 
header on this logic board that receives connectors labeled 41A and 34. 
Connector labeled 41A is a 3 pin connector and 34 is a 2 pin connector. The 
receiving header on the Logic Board is a 6 pin header, thus leaving 1 pin 
unaccounted for. The pictorial in the manual is not clear which pin on the 
Logic Board header is NOT connected by either of the 41A or 34 connectors. 
By the general convention of the other headers and connectors and review of 
the pictorial on page 4-19, it would seem that the two connectors are tight 
against one another leaving the empty pin outside the connector 34.
I would not dare apply power to the radio until I am certain of the proper 
connection.

This seems to be the only void in the information from the manual. The Logic 
Board must be removed to install the TCXO daughterboard from TT.

Thanks for any help!

73,

Joe K4MD 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec