Well of course speed is not the issue. I, too, was sending during SS
ab 26 and 28 and 30 wpm and my Titan 3 worked flawless but it was
being driven with my Omni 6 Plus. Seems like a lot of folks who use
non-Ten Tec amps, have their amps/Orion work for them in the Orion's
keying loop. My Orion will not work reliabily with the Titan 3 in
the Keying loop, but the Titan 3 and both my Omni 6 Plus and my Icom
IC-781 never have any problems. Exact same cables, etc., just change
radios. Been working this way for 16 months now.
At the present time my Orion is relegated to testing beta firmware.
Tom - W4BQF
----- Original Message -----
From: <n1eu@netscape.net>
To: <tentec@contesting.com>
Sent: Thursday, November 11, 2004 11:09 AM
Subject: Re: [TenTec] QSK/QRQ problem with Orion / ACOM 2000A
Perhaps little consolation to those afflicted, but I used my Orion
with Acom2000A in keying loop1 during SS CW and didn't have a
single rig/amp/keying glitch. However in the spirit of full
disclosure, I was operating at a tortoise-like 30wpm.
73,
Barry N1EU
"Tommy" <aldermant@alltel.net> wrote:
I know your heart's in the right place when you say that and for
sure I hope you are correct.
What makes that somewhat difficult to believe however, is the
excrutatingly slow progress with v1.372.
And then, there's the Keying Loop issue that no one wants to talk
about!
I do hope you are correct.
Tom - W4BQF
__________________________________________________________________
Switch to Netscape Internet Service.
As low as $9.95 a month -- Sign up today at
http://isp.netscape.com/register
Netscape. Just the Net You Need.
New! Netscape Toolbar for Internet Explorer
Search from anywhere on the Web and block those annoying pop-ups.
Download now at http://channels.netscape.com/ns/search/install.jsp
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|