TenTec
[Top] [All Lists]

[TenTec] CW Audio tone

To: tentec@contesting.com
Subject: [TenTec] CW Audio tone
From: "Richard Detweiler" <rdetweil@hotmail.com>
Reply-to: tentec@contesting.com
Date: Wed, 12 Jan 2005 13:34:57 -0600
List-post: <mailto:tentec@contesting.com>
Hi Bill and all,

I will second your statements here, I also use very low audio tones.

about 250 to 350, and 350 to 500 for a casual chat.

If I may add this. I think the big reason for using lower tones is that the static at the frequencies above 500 hz seem to be more annoying to me. It just seems to get in the way of the signal. So a noise floor signal is more readable if i'm not distracted by the noise.

Also, I could be wrong, but I think the Lower frequency tones has more audio energy.

Best 73's
Rich
K5SF

From: Bill Tippett <btippett@alum.mit.edu>
Reply-To: tentec@contesting.com
To: tentec@contesting.com
Subject: [TenTec] New roofing filter in Omni VI- Opt. 1
Date: Wed, 12 Jan 2005 13:35:40 -0500

W4ZV:
>I NEVER listen with CW pitch higher than 450 Hz
and normally use 270 Hz for really weak signals.

N1JM wrote:
>I wonder how many do use an offset that low?

        Apparently not many since most rigs these
days do not allow for Pitch <300 Hz.  Even going
to 300 Hz is not all that common, and most '90's
rigs only went to 400 Hz which was one reason I
never considered them.  When the FT-1000MP came
out it went to 300 Hz so I bit my tongue and
bought one.

        The issue could also be one of availability.
I used a TS-930S (and an 830 before that) for most
of my low-band DX-ing beginning in the early 80's.
Since it would go infinitely low, I was able to
learn that I could differentiate weak signals much
better at a very low pitch (as low as 240 Hz).  It
could be something unique to my ears but I believe
you will find many low-band guys who listen to sub-
noise floor signals use low pitches (ON4UN's book
notes the same).  It could very well be that since
most current era rigs don't go below 400 Hz, the
newer operators don't even realize what they are
missing since they can't easily go under 400 Hz.

        Of course in contests I use a higher pitch,
normally about 450 Hz and then offset my RX  by
200 Hz from my TX frequency to better catch off-
frequency callers quickly.

        One of the first suggestions I made to Ten-Tec
for Orion was to shift Spot below 300 Hz, and they
very kindly obliged...even down to 100 Hz which is
well below what I prefer!

73, Bill W4ZV

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>