Re: [TenTec] Omni-VI 2.8 KHz filters

["Steve N4LQ" <n4lq@iglou.com>]

Chas:
Your plans look good. The wider filters have nothing to do with the carrier 
null however should you desire to check it, hook a dummy load to the Omni 
VI, go to one of the ssb modes, key the microphone and listen for carrier in 
another receiver. You will no doubt hear some. The null adjustments are on 
the TX audio board. R3 and R4. This board is on the top, rear, left hand 
side, back under the speaker bracket. You can easily reach the pots but you 
need a tiny screwdriver. Adjust both for minimum carrier. They over react to 
the slightest twitch so just do the best you can. The PBT control is easy to 
adjust as you discovered.
Steve N4LQ
----- Original Message ----- 
From: "Charles Greene" <cgreene@cox.net>
To: <tentec@contesting.com>
Sent: Thursday, January 27, 2005 8:28 PM
Subject: [TenTec] Omni-VI 2.8 KHz filters


> Hi
>
> I got the two 2.8 KHz filters for my OMNI-VI yesterday and reviewing the 
> documentation, I can't find that it says to null the carrier again.  I 
> looked through the manual and I don't see anywhere you can null the 
> carrier.  Did I miss it?  Does the carrier null just apply to the OMNI-V? 
> I don't mind doing it, but I just can't find where it tells you how to do 
> it.  The only thing I found in the manual is setting the frequency for the 
> PBT control, which might be a good idea to do.  I have an OMNI-VI 
> purchased in 1994 with the + mod done by Ten-Tec.
>
> I also ordered the 600 Hz roofing filter, but they said it wouldn't be 
> shipped until March.  Inrad did give me a 5% discount for buying 3 filters 
> :-)
>
> I am planning install the Inrad 2.8 KHz 6.3 MHz filter in place of the 2.4 
> KHz "standard" filter, move the 2.4 KHz filter to the 1.8 KHz filter 
> position, move the 1.8 KHz filter to the .5 KHz position, leave the .25 
> KHz filter in place and relabel the filter switches.  When done, I will 
> have three different 6.3 KHz SSB filters: 2.8, 2.4 and 1.8 KHz.  I don't 
> see anything on the schematic that would keep this arrangement from 
> working.  With the 600 Hz roofing filter, I plan to have it activated by 
> either the NR1 or the NR2 switch.  I have a 500 Hz 9 MHz filter in NR1 and 
> a 250 Hz filter in NR2.  All filters are OEM except the 2.8 KHz filters 
> and the roofing filter.  Comments on this arrangement?
>
> 73,  Chas,  W1CG
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec