TenTec
[Top] [All Lists]

Re: [TenTec] is this an rf leakage problem??

To: tentec@contesting.com
Subject: Re: [TenTec] is this an rf leakage problem??
From: Duane A Calvin <ac5aa@juno.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 3 Mar 2005 09:28:49 -0600
List-post: <mailto:tentec@contesting.com>
Sounds to me like you have some source of infrared spraying your room -
perhaps one of the remotes has started to run continuously.  I don't
think it's an RF problem unless (1) you're watching TV while on the air
(you need serious help), or (2) you're running a KW within a few feet of
all your AV gear, and then I'd suspect more than just the remote control
circuitry would be experiencing problems!  So, check out the IR spectrum
and see if anything is going on there.  (The one response about sunlight
falling on the sensors is a good lead.)

        73,  Duane


On Thu, 03 Mar 2005 04:02:46 -0800 kz2g@optonline.net writes:
> Here's one for you guys.  Yesterday the remotes on my Sanyo 32" TV 
> and my Mintek DVD player stopped working.  Well, they didn't stop 
> but rather only worked from a foot away from the remote sensors.  At 
> first I only noticed the TV's remote didn't work.  So I put new 
> batteries in it then cleaned the remote sensor.  Still wouldn't 
> work.  Finally, I tried my DVD player to finish watching a DVD.  I 
> then discovered it was doing exactly the same thing as my TV remote, 
> working from just a foot away.  I checked the batteries and they 
> were fine.  Then I tried my vcr's remote.  It worked fine.  Then I 
> tried my TV and DVD remotes.  Suddenly they were working again from 
> across the room.  What they heck was going on?  The only thing I 
> could think of was that RF from my Ten-Tec Omni 6 Plus was getting 
> into the TV and the DVD's remote sensoning circuitry.  The Sanyo TV 
> was bought in October 2001.  The Mintek DVD player was bought in 
> July 2003.  The VCR is about from 1998.  Also this has happ
> ened b4.  My tv remote stops working then after several hours 
> mysteriously starts working again.  I was not using the DVD player 
> at those time, so I don't know if that was screwing up too.  But do 
> you think it could be RF from my 100-watt rig getting into the 
> remote sensoning circuitry and screwing it up for a few hours??
> 
> Bob Mauro, KZ2G Via Web Mail
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 


Duane Calvin, AC5AA
Austin, Texas
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>