Carbon tet /
----- Original Message -----
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, March 24, 2005 23:21
Subject: Re: [TenTec] First Time PTO Rebuild
> WD 40 is not a lube. It is "Water Displacement fluid formula 40."
>
> It will collect dust if used as a lube.
>
> Better to use Triflow, a true lubricant with microscopic ball bearings
> therein to loosen a tight PTO drive. Preheating the bearing, may allow
the
> oil to be sucked in better as the bearing cools.
>
> However, use of alcohol to loosen the old gunk then using Triflow may be
all
> that is needed.
>
> Complete tear down lubrication is best with the greases such as Dow 44, a
> high temperature ball bearing grease. The original petroleum grease is
the
> reason PTO's seize up over time. 44 will never harden up on you.
>
> -Stuart
> K5KVH
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|