There is a critical gain setting that sets the point where distortion and
popping will occur. The setting is done at the factory but can be done by
you if you are careful and get the instructions from Paul. Simplest is to
either turn off the preamp or add attenuation to keep the signals below 35
over 9. My Orion is adjusted so I don't get the popping or distortion until
55 over 9.
73, Tom, W7QF
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of wq7x@cox.net
> Sent: Friday, April 29, 2005 20:57
> To: tentec@contesting.com
> Subject: [TenTec] (no subject)
>
> ORION. With signal S9+35 my new Orion
> distorts audio. Is this normal with 1.372.
> Thanks. Mark WQ7X
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|