I did some measurements on the Omni VI. Nothing below 300hz get's past the
detector. The notch and DSP are not to blame. It has to do with the position
of the BFO within the IF passband.
Steve Ellington
N4LQ@iglou.com
----- Original Message -----
From: "Barry Gross" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, May 29, 2005 8:39 AM
Subject: Re: [TenTec] SSB recieve audio?
> The ARRL measured Omni VI ssr rx audio bandwith at 1630hz, with 2.4Khz
> wide filters. The bandwith is limited by active and passive
> components that are always in the audio signal path.
>
> I measured the Orion audio bandwith at 5500hz, with the bandwith
> opened up to the maximum 6Khz. TT handily met their stated design
> goal of giving the stock Orion fantastic ssb audio quality. Besides
> the fidelity, it's generally a very non-fatiguing radio to listen to
> for long periods of time because the receiver and audio chain are very
> "clean."
>
> 73,
> Barry N1EU
>
>
> On 5/28/05, denton <denton@oregontrail.net> wrote:
>> Wonder how the Orion's SSB audio sounds compared to an Omni VI??
>> For some reason, to my ears, my FT990 seems to sound better than my Omni
>> VI
>> on ssb.
>> ----- Original Message -----
>> From: "John L Merrill" <jmerrill1@adelphia.net>
>> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
>> Sent: Saturday, May 28, 2005 2:51 PM
>> Subject: Re: [TenTec] Propm RX
>>
>>
>> >I have an R4A I've been repairing here on the bench and with the same
>> > speaker, it sounds better than the Orion :-).
>> >
>> > John N1JM
>> >
>> > Grant Youngman wrote:
>> >>
>> >>
>> >>>I agree. The receive audio is lousey on the Orion.
>> >>
>> >>
>> >> Maybe you just need a decent speaker. Or perhaps your inner ear needs
>> >> some
>> >> work :-)
>> >>
>> >> The Orion has excellent SSB receive audio, as good or better than any
>> >> HF
>> >> rig
>> >> I've used (many, new and old), and generally requires little in the
>> >> way
>> >> of
>> >> receive EQ. I do much prefer it with a little more than the usual
>> >> bandwidth
>> >> (say around 3 Khz or so), but that's no different than most radios
>> >> which
>> >> sound like cr*p at the typical narrow bandwidths everyone want to use.
>> >>
>> >> Of course, it would benefit greatly from a pair of P-P 6V6's in the
>> >> output
>> >> stage, but I doubt that's in the plan :-)
>> >>
>> >> Grant/NQ5T
>> >>
>> >>
>> >> _______________________________________________
>> >> TenTec mailing list
>> >> TenTec@contesting.com
>> >> http://lists.contesting.com/mailman/listinfo/tentec
>> >>
>> > _______________________________________________
>> > TenTec mailing list
>> > TenTec@contesting.com
>> > http://lists.contesting.com/mailman/listinfo/tentec
>> >
>> >
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|