| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] 2.028 is out - error message |
| From: | RaySoifer@cs.com |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 9 Jan 2006 23:15:54 EST |
| List-post: | <mailto:tentec@contesting.com> |
Carl and others, Thanks! It turned out that the software was trying to use COM2 while the serial port was COM1. The new firmware is now loaded into the O2, and I've done the recommended master reset. Hope it works! 73, Ray W2RS _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] 2.028 is out - error message, Grant Youngman |
|---|---|
| Next by Date: | Re: [TenTec] 2.028 is out - error message, Grant Youngman |
| Previous by Thread: | Re: [TenTec] 2.028 is out - error message, Grant Youngman |
| Next by Thread: | [TenTec] 2.028 is out - error message, Don Rasmussen |
| Indexes: | [Date] [Thread] [Top] [All Lists] |