That's good information, Rick, and seems to indicate that this is not a
problem with too high voltage, although running more than 15 Volts as the
Titan 425 does is probably still not a good idea. This confirms to me that
it's simply something that got broke in the new firmware update.
Ron N6AHA
----- Original Message -----
From: "Rick Williams" <rick.williams@telus.net>
To: <tentec@contesting.com>
Cc: <ronc@sonic.net>
Sent: Monday, March 06, 2006 8:50 PM
Subject: Re: [TenTec] Observatons
> Ron I finally got behind the rack and the voltage was 13 VDC.
>
> 73,
>
> Rick
> VE7TK
>
> Website: http://www3.telus.net/ve7tk
>
> -----------
> Subject: Re: [TenTec] Observatons
> From: "Ron Castro" <ronc@sonic.net>
> Reply-to: Ron Castro <ronc@sonic.net>,Discussion of Ten-Tec Equipment
> <tentec@contesting.com>
> Date: Mon, 6 Mar 2006 17:58:47 -0800
>
> Rick...what is the voltage on the line going between TX Out on the Orion
> and
>
> the Key In on the Hercules. The voltage is supplied by the amp...the TX
> Out
>
> on the Orion just pulls the + amp voltage to ground with an NPN
> transistor.
> The Orion manual says not to switch more than 15 V, but on my Titan, the
> voltage is +24 V, which may be part of the problem.
>
> Ron N6AHA
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|