TenTec
[Top] [All Lists]

Re: [TenTec] 961 power supply question ...

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] 961 power supply question ...
From: "Mike Brown" <k9mi@sbcglobal.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 10 Jul 2006 04:20:08 -0000
List-post: <mailto:tentec@contesting.com>
5 watts will never be seen to who you are talking to. Run you're radio at 95 or even 90 and save you're radio. I wouldn't worry about 5 watts. If it gets down to 80, then maybe worry a little bit about it.

That current limiter has saved a lot of guys bacon over the years.

73, Mike K9MI


----- Original Message ----- From: "William Lee" <n5wrx@stx.rr.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, July 07, 2006 21 54
Subject: Re: [TenTec] 961 power supply question ...




I am using a 961 power supply to power my Pegasus radio.
When I use full output power it sometimes trips the power supply on a
voice peak.
Since the antenna is less than 1.5 SWR I doubt it is because of that.
Cutting the power back to about 95 watts cures the problem.
I suspect that the limiter in the power supply is set a bit to low.
I have bought two Ten Tec radios in the last few months and both came
with a 961 power supply but no manual.
Is there a current limiter adjustment in the power supply or is it
fixed?

William Lee  N5WRX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




<Prev in Thread] Current Thread [Next in Thread>