TenTec
[Top] [All Lists]

Re: [TenTec] Orion 2 and DxBase 2005

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion 2 and DxBase 2005
From: "Carl Moreschi" <n4py@arrl.net>
Reply-to: Carl Moreschi <n4py@arrl.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 25 Jul 2006 15:23:38 -0400
List-post: <mailto:tentec@contesting.com>
The Orion only runs at 57600 baud, 8 bit, no parity, 1 stop bit.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "G3RXP" <g3rxp@btinternet.com>
To: <tentec@contesting.com>
Sent: Tuesday, July 25, 2006 3:06 PM
Subject: [TenTec] Orion 2 and DxBase 2005


> Hello All
>
>
> My DxBase 2005 logging program does not appear to have a default baud rate
for the Orion 2 and I cannot get it to talk. N1MM works OK so the physical
link is there. Can I change the default baud rate on the Orion to match
DxBase 2005?  or visa versa?
>
> Many Thanks
> Dave G3RXP
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>