Re: [TenTec] Orion 2 and DxBase 2005

["G3RXP" <g3rxp@btinternet.com>]

Carl     Many Thanks -  fixed.
73 Dave G3RXP


----- Original Message ----- 
From: "Carl Moreschi" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, July 25, 2006 8:23 PM
Subject: Re: [TenTec] Orion 2 and DxBase 2005


> The Orion only runs at 57600 baud, 8 bit, no parity, 1 stop bit.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> ----- Original Message ----- 
> From: "G3RXP" <g3rxp@btinternet.com>
> To: <tentec@contesting.com>
> Sent: Tuesday, July 25, 2006 3:06 PM
> Subject: [TenTec] Orion 2 and DxBase 2005
>
>
> > Hello All
> >
> >
> > My DxBase 2005 logging program does not appear to have a default baud 
> > rate
> for the Orion 2 and I cannot get it to talk. N1MM works OK so the physical
> link is there. Can I change the default baud rate on the Orion to match
> DxBase 2005?  or visa versa?
> > Many Thanks
> > Dave G3RXP
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.394 / Virus Database: 268.10.4/396 - Release Date: 24/07/2006