Use the RIT - make it read whatever you want within reason - or use Hyper
terminal in Windows and send RS232 commands to the Orion - then you can do
RIT in 1 hz steps.
73 de Hank K7HP
----- Original Message -----
From: "Ron Castro" <ronc@sonic.net>
To: <geraldj@storm.weather.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Tuesday, August 08, 2006 3:00 PM
Subject: Re: [TenTec] Orion II - Tech Topics
> Then I'm a whole kHz off instead of only 20 Hz!!!
>
> Ron N6AHA
>
> ----- Original Message -----
> From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
> To: <tentec@contesting.com>
> Sent: Tuesday, August 08, 2006 1:42 PM
> Subject: Re: [TenTec] Orion II - Tech Topics
>
>
>> On Tue, 2006-08-08 at 13:31 -0700, Ron Castro wrote:
>>> Well, you're right about that! Looking at the dial read 14.328.980 bugs
>>> me
>>> though...
>>>
>>> Ron N6AHA
>>>
>> So cover the last three digits with black tape. Or adjust the software
>> to read only to the nearest KHz.
>> --
>> 73, Jerry, K0CQ,
>> All content copyright Dr. Gerald N. Johnson, electrical engineer
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|