TenTec
[Top] [All Lists]

Re: [TenTec] Orion2 Problem with indication of the analog meter

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion2 Problem with indication of the analog meter
From: "Ron Castro" <ronc@sonic.net>
Reply-to: Ron Castro <ronc@sonic.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 13 Sep 2006 21:14:24 -0700
List-post: <mailto:tentec@contesting.com>
I have found the same problems with the meter, especially on the S-meter 
readings above S-9.  If you look at my website, www.N6AHA.com, you can see 
the result of my measurement of the S-meter.  This was measured under an 
older firmware version, and I have not had a chance to check v. 2.037J yet, 
but I don't think it has changed.  If you use the N4PY rig control software, 
you can get an accurate reading above S-9 on your computer.

As for the power output, I also found that the analog meter was not correct, 
but the digital setting shown next the PWR button was very close to the real 
power that I measured with a Bird 43 Wattmeter into a dummy load for all 
levels from 10 to 100 Watts.  I use the PWR setting to determine drive power 
for my amplifier.

Ron N6AHA

----- Original Message ----- 
From: "Nikolai Kuprin_UA9KM" <ua9km@ongp.ru>
To: <tentec@contesting.com>
Sent: Wednesday, September 13, 2006 8:45 PM
Subject: [TenTec] Orion2 Problem with indication of the analog meter


> Hello ALL!
> I am the new user of this transceiver. My previous transceiver - Kenwood
> ts850.
>
> On a problem about which I want to tell, has paid attention when has
> connected the transceiver to the power amplifier.
>
> For reception of the maximal target capacity of the PA it is enough to
> submit from the transceiver of 20-25 watt. Adjusting target capacity of 
> the
> transceiver up to a level of 25 watt I receive the maximal target capacity
> of the PA. This level shows the ORION II screen display. During same time
> the analog meter of the transceiver shows 50 watt, i.e. the level of
> indications of an analog meter is higher in 2 times.
>
> In case of use of the transceiver without the PA, exposing a level of 100
> watt on the screen display, the arrow of the analog meter deviates sharply
> to the right against the stop.  It can lead to technical malfunction of 
> the
> analog meter.
>
>
> I now doubt of correctness of indications of S-meter because the analog
> indicator shows all signals 59+40 and more.
>
> What your recommendations for elimination of the  problem?
>
>
> Nikolai, UA9KM
>
> PS/  am sorry for my weak English.....
>
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>