Would it be difficult to make a new bushing to replace the worn one?
Sounds like a simple lathe job. Is it brass/bronze or plastic (teflon)?
----- Original Message -----
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
To: <tentec@contesting.com>
Sent: Thursday, May 11, 2006 11:15 AM
Subject: Re: [TenTec] roller inducter help
> On Thu, 2006-05-11 at 04:10 -0700, W EC wrote:
>> Hi everyone,I am asking for info. or help again. Does any one know a
source to buy a roller inductor or how to repair one? My roller inductor's
shaft on one side is loose(the metal collar that goes into the insulator)
the tuner is a denton dtr-3000. Replies off line are ok. Thanks, Cordy @
yahoo.com
>>
>>
> It shouldn't be hard to repair the worn bushing hole. Probably drill it
> out larger and slip in a new bushing the larger OD to fit the new hole
> and the right size for the shaft or maybe a bushing that bits the
> outside of the existing bushing and then make the new hole in the
> insulator plate large enough for that bushing. A simple repair in a
> machine shop.
>
> --
> 73, Jerry, K0CQ,
> All content copyright Dr. Gerald N. Johnson, electrical engineer
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
--------------------------------------------------------------------------------
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|