Think you are probably right Carl - at least hopefully -(it has gotten even
worse now so looks very much like a regulator going kaput ) - but I just
looked at the 81917A7 CPU/DSP regulator schematic and they are things I
cannot get locally tomorrow and get them installed by 2pm so I guess I will
set the O aside and hook up my TR7/R7.But maybe I can avoid a trip back to
TT with it. Besides I am not looking forward to pulling the front panel
again to get to those regulators!
73 de Hank K7HP
----- Original Message -----
From: "Carl Moreschi" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, November 03, 2006 8:17 PM
Subject: Re: [TenTec] ORION died
> It sounds like an internal voltage regulator is messed up to me. I would
> check all the internal voltages from the regulators.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, North Carolina 28635
>
> ----- Original Message -----
> From: "Pfizenmayer" <pfizenmayer@worldnet.att.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Friday, November 03, 2006 9:07 PM
> Subject: Re: [TenTec] ORION died
>
>
>> Any real Orion Gurus have any ideas - This afternoon I was working a guy
> on
>> 20 cw noticed the LCD display was blinking with keying . Tried changing
>> contrast etc etc no help. Looked at PS current - was under 20 amps key
>> down - power just under 100 watts . Tried into dummy load same LCD
>> flickering , same currents and power.
>>
>> Tried other bands - no difference - Tried reducing power - no difference
> in
>> flickering until under 16 relative power setting. Decided to check power
>> supply (ASTRON 35 M ) voltage drops under load and fuse and DC supply -
> all
>> looked OK. less than half volt from 13.8 to 13.3 .
>>
>> Turned off and mulled a bit - tried turning it back on and now it will
>> not
>> boot - treid doing a RAM clear - could faintly see battery message at top
> .
>> OFF and ON and no difference will not boot. Tried a master reset - cannot
> do
>> it.
>>
>> When the thing comes on the red ALC LED lights dimly - - the SYSTEM
> LOADING
>> message shows up dimly then fades out in about two or three contrast
> steps
>> every 5 seconds - repeats - sometimes the Smeter will light up breifly ,
>> a
>> relay clicks and it repeats but this is random. I might also note the LCD
>> display is sort of blue at turn on the goes to grey and black.
>>
>> Any ideas for me tonight - ??? . It worked fine all weekend last weekend
> in
>> CQWWPH.Worked fine all week on random qso's - all cw.
>>
>> Looks like I am most likely back to my TR7 for CWSS.
>>
>>
>> ???? Thanks _ Hank K7HP
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|