TenTec
[Top] [All Lists]

[TenTec] CW on Corsair II

To: tentec@contesting.com
Subject: [TenTec] CW on Corsair II
From: Paul <designer@quickdata.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 18 Feb 2007 16:25:12 -0800
List-post: <mailto:tentec@contesting.com>
I just got my Corsair II back from Ten Tec for a PTO rebuild and 
check up - so I'm sure it works. I never operated the rig before - 
sent it to Ten Tec as soon as I got it - so I must be missing 
something simple in the setup.  I plugged in my Kent key with 1/4 
inch stereo adapter (tested that combination on an MFJ keyer) to the 
"keyer paddle" jack in the back. When I turn the switch to CW and 
push the paddle one way or the other I get nothing - no side tone, no 
meter reading in FWD position. Does this require an external T/R 
switch or something else I am missing?

For SSB I hoped I could use the 706 mic that came with the ArgoV. But 
it doesn't seem to trigger much either. Following the manual, I put 
the mode switch on Lock and adjusted the drive till the ALC (ALC 
control fully CW) flickered. Then I switched over to SB-N and called 
CQ. I adjusted the ALC to about 1 O'clock position to get it to 
flicker. The FWD power would hover around 10W.

So maybe the 706 mic isn't compatible with the Corsair II? Maybe 
there is some additional switch that need to be set for CW. I haven't 
adjusted the Side tone volume/tone thumb wheels under the unit and I 
haven't tried going through an external keyer to the Key RCA yet.

Finally, what should I expect when I push the Spot button? In 
yesteryear I'd expect some kind of tone used to zero beat or listen 
for a 750Hz note that appears, according to the manual, to be the 
fixed CW offset.

I have operated other gear before - just don't know how this Corsair 
should respond. If I sent it in for a PTO rebuild and InRAD and 
TenTec filter install, and checkout, I'm sure it would come back 
ready to go. Just can't find that "go" switch. What simple thing am I 
missing?

Thank you and 73,
Paul

PS: Corsair lovers or wantabe lovers watch this space. Once I verify 
all is working fine, I might sell it with full filter compliment, 
matching speaker power supply, and the rare external VFO for dual RX.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>