N1 and N2, if I remember correctly, are for selecting first IF (9 MHz)
filters. The passband tuning works on the 2nd IF (6.3 MHz).
73, Duane
Duane Calvin, AC5AA
Austin, Texas
www.ac5aa.com
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Denton
Sent: Friday, April 20, 2007 4:52 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni VI Pass Band Tuning CW Narrow
No..not to my observation
----- Original Message -----
From: "John Huffman" <hjohnc@adelphia.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, April 20, 2007 2:39 PM
Subject: Re: [TenTec] Omni VI Pass Band Tuning CW Narrow
> Denton -
>
> Thanks for the reply. I don't do PSK. Can you click in N2 only and then
> move the
> passband with PBT???
>
> 73 de K1ESE
> John
>
> Denton wrote:
>> If you are running psk like I do....center the recieved signal on 2000
>> hrz
>> on the waterfall, click in N2. Anything below 2000 hrz just
>> dissapears...click in the additional 250 hrz cw filter and one can use
>> psb
>> to really narrow down the passband to just only seeing the one psk
>> signal.
>> Wonder if the new Omni 7 can do this?
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|