TenTec
[Top] [All Lists]

Re: [TenTec] Orion at Field Day

To: <kd3jf@arrl.net>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion at Field Day
From: "David S. McCallum" <w7sac2@cox.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 26 Jun 2007 07:25:48 -0500
List-post: <mailto:tentec@contesting.com>
Carl were you using the Omni Vll through a computer set up or just a basic 
radio via a power supply?. Just wondering , Mac 
----- Original Message ----- 
From: Paul Gates, KD3JF 
To: Carl Moreschi ; Discussion of Ten-Tec Equipment 
Sent: Tuesday, June 26, 2007 5:08 AM
Subject: Re: [TenTec] Orion at Field Day


Carl, I did not participate in Field Day on Saturday but my YL and I went to 
Fort McHenry national Park near Baltimore and "captured" a picnic table. In 
fact we got there before the Park opened at 8AM. I clamped my MP1 vertical to 
the picnic table and threw the counterpoise under the picnic table. Then hooked 
up my Elecraft KX1 with a Li-POL battery and we off. I had figured that in the 
morning before Field Day I would make some contacts with 3 watts. And sure 
enough I first worked a Tenn. station working CW of course.

It would have been super nice to have a Ten Tec Argo V but maybe that will come 
in a few months.

Carl Moreschi <n4py@arrl.net> wrote: Both my Omni VII and Orion were used at 
field day.  Each radio made about
1000 QSO's. They both performed flawlessly and handled the excessive QRM
beautifully.  80 percent of our QSO's were made on CW.  We had 2 dipoles
each for 80, 40 and 20 meters.  We used the 40 meter dipoles also on 15
meters.  We were at a site with a 120 foot fire tower.  So we used the fire
tower to support most of the dipoles.  We had 2 dipoles for each band at
right angles to each other.  We did this to avoid the null off the end of
the dipoles.  I would call CQ on an east-west dipole and stay with that
antenna until I did not get an answer to a CQ then switch to the other.
This technique caused us to be on the best antenna favoring the propagation
direction at all times.

My Orion had firmware 2.062a in at and performed perfectly.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Ron Castro" 
To: "Ten Tec List" 
Sent: Monday, June 25, 2007 2:55 PM
Subject: [TenTec] Orion at Field Day


> I upgraded an Orion to v. 1.373b5 to run in our Field Day event this year
with the Redwood Empire DX Assn. and the Marin Amateur Radio Society.  You
can see an interesting newspaper article published in yesterday's Marin
Independent Journal with a picture of me operating the Orion at
www.N6IE.com!
>
> The rig with the updated firmware was much improved over the previous
original version although I don't recall which one was in it before.  Last
year, there were reports of crashing at least once per hour or more.  This
time, running all SSB and over 1,000 QSO's, we had only two lock-ups during
the course of the event.  I suspect that the newest v. 2.x is better and
advised the rig's owner to do the hardware mod and upgrade.
>
>                      Ron N6IE
>                 www.N6IE.com
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>