TenTec
[Top] [All Lists]

Re: [TenTec] New Omni VII....first impressions

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] New Omni VII....first impressions
From: Ernie Piche N1SW <n1sw@cox.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 20 Dec 2007 17:31:37 -0500
List-post: <mailto:tentec@contesting.com>
Stuart Rohre wrote:
> Mike, if you have the very oldest D 104, the bad audio reports you describe 
> are typical of an impedance mismatched D104.   It is a high impedance mike. 
> To use it for modern low to medium impedance SSB mike inputs, you need a 
> matching transformer, or an emitter follower preamp to step down the 
> impedance from the 100,000 ohm range to say 600 ohms.  Then, the mike will 
> sound great.  I use the D104 very successfully with Ten Tec rigs with 
> attention to matching.
>
> 73,
> Stuart Rohre
> K5KVH 
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>   
Check out Heil they make a replacement element for the D104 and it works 
GREAT!
Ernie
N1SW
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>