| To: | <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] 041 firmware rev |
| From: | "Dennis Duffin" <duffind@verizon.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 27 Feb 2009 13:55:53 -0600 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I have noticed a couple of times after the rig has been on for some time, the scope turns all red (signal indicators are still white) and then lines start running from top to bottom. First time, I did a master reset and it went away. This past time I simply turned off the sweep and turned it back on and it was normal again. Anyone experienced this yet?? Dennis W5UV _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Orion II - 2.041 XL is Posted, kc9cdt |
|---|---|
| Next by Date: | Re: [TenTec] 041 firmware rev, Ron Castro |
| Previous by Thread: | Re: [TenTec] 041 firmware rev, Douglas Shock |
| Next by Thread: | Re: [TenTec] 041 firmware rev, Ron Castro |
| Indexes: | [Date] [Thread] [Top] [All Lists] |