Well not having a lot of luck here. Somehow crashed the O2 first time
trying with an old serial card in the PC, and it was very slow. Got a USB
to serial converter and it flashed in about 5 mins this time but nothing in
the radio works, no knob, no buttons, and the display reads all zeros
frequency. Am trying the flash again. Stay tuned. So far I am
underwhelmed.
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Peter Frenning [OZ1PIF]
Sent: Friday, February 27, 2009 3:57 PM
To: Ron Castro; Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] 041 firmware rev
Ron Castro skrev:
> I have noticed that the levels between the AF and RF AGC's are quite
> different. The AF is very low compared to RF.
>
> Ron Castro
> Chief Technical Officer
> Results Radio, LLC
> N6IE
> www.N6IE.com
>
Same here, but doesn't seem to have detrimental effects other than you
have to twist up the AF encoder...
--
Vy 73 de OZ1PIF/5Q2M, Peter
** CW: Who? Me? You must be joking!! **
email: peter(no-spam-filler)@frenning.dk
http://www.frenning.dk/oz1pif.htm
Ph. +45 4619 3239
Snailmail:
Peter Frenning
Ternevej 23
DK-4130 Viby Sj.
Denmark
***********************************
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|